top of page

1N4007 Diode: Specifications, Polarity and Applications

Nov 13
2 min read

The 1N4007 is a general-purpose silicon rectifier: it conducts primarily in one direction and is commonly used to turn low-frequency AC into DC. The Hornby version is an axial, through-hole DO-41 device. Its band marks the cathode, which is the first detail to check before placing it on a breadboard or PCB.


1N4007 axial diode with anode at the unbanded end and cathode at the striped end
The stripe marks the cathode (K); the opposite lead is the anode (A).

What do 1 A and 1000 V actually mean?


The headline current and reverse-voltage figures describe different operating conditions. They do not mean that the diode can dissipate 1000 watts or that a beginner circuit should operate at mains voltage. A circuit designer must consider current waveform, heat, voltage spikes and mounting as well as the headline numbers.


Hornby parameter

Value and condition

Repetitive peak reverse voltage

1000 V maximum

Average rectified forward current

1 A with 9.5 mm leads at 75°C ambient

Forward voltage

1.1 V maximum at 1 A DC and 25°C

Non-repetitive surge current

30 A for one 8.3 ms half-sine pulse

Package and polarity

DO-41; banded end is cathode (K)


A surge rating covers a short event under specified conditions. It is not permission to run a 30 A load continuously. Likewise, the forward-voltage limit in the table is not the voltage every multimeter will display: diode-test current is usually much lower than the datasheet test current.


How to identify anode and cathode


Look for the stripe around one end of the body. That end is the cathode (K); the unbanded end is the anode (A). In a forward-conducting circuit, conventional current flows from anode to cathode. Follow your circuit schematic rather than treating the band as a universal connection to ground: its required connection depends on the diode's job.


Where it is useful


  • Low-frequency rectification in an appropriately rated isolated supply circuit.

  • Reverse-polarity blocking when the resulting voltage drop and power loss are acceptable.

  • Flyback suppression across a suitable DC relay coil, with the diode reverse-biased during normal coil energization.


For example, across a transistor-switched DC relay coil, the cathode normally goes to the coil's positive supply side. The diode then offers a path for coil current after switch-off. Coil current, release-time requirements and driver design still need checking. A relay module may already contain protection, so inspect its schematic before adding parts.


When to choose another diode


Do not choose a diode for a switching converter or PWM motor circuit from reverse voltage alone. Recovery behavior, current peaks, temperature and the driver topology matter. Use the diode type specified by the circuit designer; a fast-recovery or Schottky part may be appropriate where a general-purpose rectifier is not.


Choosing a pack and checking your circuit


Our product offers selectable packs of 1, 5, 10, 50, 100 and 500. Check the selected pack and cart quantity before purchase; a gallery photo containing several diodes does not define the order quantity. A four-diode bridge uses four components, while a simple relay flyback circuit often uses one.




Sources and further reading




 
 
 

Comments

Rated 0 out of 5 stars.
No ratings yet

Add a rating
bottom of page